Note: Installing spring plates is a very dangerous task and should never be attempted by an amateur or without using the proper installation tools. If you are not a competent mechanic - DO NOT ATTEMPT TO INSTALL!

Atomwerk Designs LLC,  Engineering & Manufacturing. All rights reserved |  Privacy Policy | Terms of Use | Links | Retailers

Racing Series Build-a-Beam

We are proud to present our long awaited Racing Series Build-a-Beam! This beam is far more rigid, precise, and adjustable. They are composed of many pieces and parts can swap out. You can set it as a low rider, standard, or baja and still have full adjustability (7.5") in each of those ranges. Each beam has full bronze bushings, where the squeeze can be adjusted to your particular control arms, thereby allowing you to set your control arms for maximum tightness and rigidity, a quality that cannot be done with needle bearings or especially plastic bushings, including Delrin. The end user will have an experience similar to engine building, as these beams can be assembled in different ways. Plus they are a part of our complete suspension puzzle, where the next products we offer will bolt up easily to this beam. These beams will or course take the common sway bars that reduce ground clearance, however will be the only beams that can take our up coming mid-mounted adjustable-torsion sway bars, which attach to our lower control arms on the inside. Additionally since they are made of both steel and aluminum they are lighter yet stronger!

 Email us for information about how to get a beam like this for yourself: atomwerk@gmail.com

Accepts our Upcoming Central-Mounted Adjustable-Torsion Sway Bars and our Adjustable Two-Piece Control Arms!