atomwerk@gmail.com Atomwerk Engineering WAS about  quality! We believed that quality  comes WAY before quantity! We  stuck to our guns to the end.

Note: Installing spring plates is a very dangerous task and should never be attempted by an amateur or without using the proper installation tools. If you are not a competent mechanic - DO NOT ATTEMPT TO INSTALL!!!

Atomwerk Engineering Inc. All rights reserved |  Privacy Policy | Terms of Use | Links | Retailers

Introductory Drop Plates and Raise Plate Sets


These are our introductory Drop/Raise Plates so you can start riding low in comfort and style immediately! These plates are sold in sets and are constructed from laser cut, factory thickness, grade 50 tool steel spring plates, and 1026 carbon steel Spline Stubs that are 1.75" in diameter. We offer these plates with instructions and all the technical support that is necessary to install on your VW headache free. These Drop/Raise Plates come standard with a powder coat finish, which is far more durable and beautiful than the industry-standard cheap zinc coatings that you will find on most suspension components. Other colors are available in powder coating for $20 extra. They come in the following increments:


IRS:

Stock Height

1.0” Drop

2.0” Drop

3.0” Drop

1.0” Raise

2.0” Raise

3.0” Raise


Keep in mind when making your selection that each spring plate has a variance of an inch in either direction. For example if you wanted to drop your VW 3.25” then you should purchase the 3” Drop Plates and then index them on your VW so that it sits 3.25”. Also type 2 or 930 CV joints are necessary for the 3.0” IRS raise plates so that the axles will not bind.



*Note: Bushings with 1.75” ID proper shocks and are necessary for a complete rear suspension.


IRS Twin Raise Plate, 26 9/16” Length Torsion Bars

Click here to tell how long your torsion bars are and to see what suspension type you have.

Click here to tell how long your torsion bars are and to see what suspension type you have.

 IRS Single Drop Plate, 26 9/16” Length Torsion Bars

IRS Twin Raise Plate, 26 9/16” Length Torsion Bars

Billet Dust Covers

Our medium-stub and long-stub(not short stub) spring plates are designed with open ends on purpose so that the torsion bar can be installed from the outside if the installer chooses to. Click here to see. However for those who insist on a clean look and do not want the torsion bar exposed to the elements, we manufacture dust covers. They are made from either billet aluminum or billet stainless steel, and use 3 set screws to hold firmly into place.

Click here to tell how long your torsion bars are